NitroData [Chip Tuning Box] for Motorbikers, ORIGINAL
The NitroData is a power box for bikes, with box you can get more power & torque for your bike.
To fit the NitroData you will need to locate the air temperature sensor (IAT) which is located near the air box on most bikes.
Disconnect the plug connectors which are already attached to the IAT and attach the plug connectors of the NitroData module to the relevant connector of the IAT. The NitroData is now ready to use.
or behind the dashboard/front headlight on Ducati bikes your user manual for the location or contact your reseller or DM (please either check your user manual for the location).
As some motorcycles run richer and others are leaner, we suggest that you start by using the NitroData with the dial set to minimum and gradually increase the dial to a higher until you find the setting which is best for your bike A slightly modified engine (sport exhaust,air filter etc.)will generally have a better performance with the dial set around midle if the bike has an aftermarket
exhaust system fitted. A setting between midle and midle more can be used when the catalytic converter has been removed.The original standard performance is to be found at minimum setting on control unit.
If the bike running richer then the setting will probably need to be set between litle then minimum. You will feel from the performance of the motorcycle when the engine is running smoothly and it is not necessary to run a Dyno test. Please avoid falling into the trap of thinking the higher the maximum the better the performance as it will vary depending on the bike. If it appears that you are losing the torque when you hit high speeds this most probably means that you have set the NitroData number too high and need to try a lower setting.
This is another reason why it’s better to start with a low setting and to gradually turn the dial to a maxmimum setting.